> atz # reset ELM chip
ELM327 v1.4b
> atd # set all settings to defaults
OK
> atsp6 # select protocol 6
OK
> atcfc1 # can flow control on
OK
> stcsegr1 # turn CAN Rx segmentation on
OK
> stcsegt1 # turn CAN Tx segmentation on
OK
> atsh750 # set the header of transmitted OBD messages
OK
> atcra758 # set CAN hardware filter
OK
> atceaAE # use CAN extended address hh
OK
> attaAE # set tester address to hh
OK
> stcfcpc # clear all flow control address pairs
OK
> stcfcpa 750 AE, 758 AE # add flow control address pair
OK
> 222006 # protocol 6 message to check status of ESE (last number in response: 0 - ESE is off, 1 - ESE is on)
62 20 06 01 01
> 3E1 # protocol 6 message preparation
7F 3E 13
> 1003 # protocol 6 message preparation
50 03 00 32 01 F4
> 2E20060100 # protocol 6 message to turn off ESE
6E 20 06
> 2E20060101 # protocol 6 message to turn on ESE
6E 20 06