Cycle never marked finished after 0.40 unless force ended

[trnovak]

Hello,

I have a washer that (for some reason) draws 2W even when off. I had pre-0.40 WashData installed with the minimum power setting set to 4W. This worked perfectly for dozens of cycles. Now, after 0.40 with the same settings, cycles never end (state stays "ending" forever, even after power goes back to 2W consistently, until I force it to end). I've tried completely removing the integration and re-installing twice. Any ideas what could be happening?

[3dg1luk43]

New update pushed where I tried to address this exact problem. Unfortunately I focused too much on 0W readings and neglected min power. Please, try again with 0.4.2.

[trnovak]

I tried again with 0.4.2.1; same thing is happening. I didn't adjust any settings or reinstall the integration this time.

[Twenty5Schmeckels]

Checking in as I’m having a similar issue, and I’m also on 0.4.2.1.

[christer-svg]

I have a similar problem. It takes forever to end the cycle so when we run the washer again after the first is finished it will be one long cycle. If you look at the graph when it says off I want it to also be finished and not ending. You can se that it goes from running->paused->ending->starting->running. Without any finished