[Request] Ability to reuse source file after conversion is finished/stopped.

[antonio1475]

Currently, once you've pressed Start after setting up the parameters, it's done. You cannot change one parameter and do it again.

As far as I know, you can only add the source again and... set all the parameters again.

Assuming that my understanding is correct, is it possible to just allow changing the parameters and use Start again? i.e. un-block the controls after the converstion and the state has changed to Ready.

The source should remain as an (available) source, no?

Screen.Recording.2026-05-04.at.14.03.mp4

PS: there should probably also be a stop/cancel button, not just pause. If you mess up with one parameter and it takes too long (eg. upscaling), then you have to start over too.

Screen.Recording.2026-05-04.at.14.01.mp4

Thank you 🙏 😄

[66HEX]

Good call, I'm going to address this as soon as I finish working on preview engine