Hi, I want to calibrate my mavic mini the gimbal using the dji firmware tool through the python software, but I get the following error messages, how can I solve this problem?
I am trying to do it on my mavic mini - WM160 but i get an error that says :
py comm_og_service_tool.py -vv COM4 WM160 GimbalCalib JointCoarse
Opened COM4 at 9600
info: The Gimbal will move through its boundary positions, then it will fine-tune its central position. It will take around 15 seconds.
Prepared binary packet:
55 0e 04 66 0a 04 5b 90 20 04 08 01 0b 78
Sending packet...
Waiting for reply...
Retrieved 1 packets (14b), dropped 0 fragments (0b)
Received response packet:
55 0e 04 66 04 0a 5b 90 80 04 08 01 1a 6c
Error: Unrecognized response to calibration command JointCoarse request.
py comm_og_service_tool.py -vv COM4 WM160 GimbalCalib LinearHall
Opened COM4 at 9600
Info: The Gimbal will slowly move through all positions in all axes, several times. It will take around 30 seconds.
Prepared binary packet:
55 0e 04 66 0a 04 c0 9a 20 04 08 02 0f 6c
Sending packet...
Waiting for reply...
Retrieved 1 packets (14b), dropped 0 fragments (0b)
Received response packet:
55 0e 04 66 04 0a c0 9a 80 04 08 01 85 4a
Error: Unrecognized response to calibration command LinearHall request.
Where is the problem ?
Thankyou.
Hi, I want to calibrate my mavic mini the gimbal using the dji firmware tool through the python software, but I get the following error messages, how can I solve this problem?
I am trying to do it on my mavic mini - WM160 but i get an error that says :
py comm_og_service_tool.py -vv COM4 WM160 GimbalCalib JointCoarse
Opened COM4 at 9600
info: The Gimbal will move through its boundary positions, then it will fine-tune its central position. It will take around 15 seconds.
Prepared binary packet:
55 0e 04 66 0a 04 5b 90 20 04 08 01 0b 78
Sending packet...
Waiting for reply...
Retrieved 1 packets (14b), dropped 0 fragments (0b)
Received response packet:
55 0e 04 66 04 0a 5b 90 80 04 08 01 1a 6c
Error: Unrecognized response to calibration command JointCoarse request.
py comm_og_service_tool.py -vv COM4 WM160 GimbalCalib LinearHall
Opened COM4 at 9600
Info: The Gimbal will slowly move through all positions in all axes, several times. It will take around 30 seconds.
Prepared binary packet:
55 0e 04 66 0a 04 c0 9a 20 04 08 02 0f 6c
Sending packet...
Waiting for reply...
Retrieved 1 packets (14b), dropped 0 fragments (0b)
Received response packet:
55 0e 04 66 04 0a c0 9a 80 04 08 01 85 4a
Error: Unrecognized response to calibration command LinearHall request.
Where is the problem ?
Thankyou.