Using the M5 cc1101 module?

[hammersap48-sys]

https://docs.m5stack.com/en/module/Module_CC1101

I'm trying to use this module with the M5 Fire, but I may have an issue understanding my device. Would I use this with the cc11o1 option within the RF configuration, or is this just going to increase my normal RF within the fire? Thank you in advance all help appreciated.

[0Zane]

Once everything is wired up , you will need to go to :
RF -> Config -> CC1101

Otherwise it will not consider the module.
If it says "CC1101 not found", check the wiring , but it would also display the error with a good wiring sometimes, try rebooting it in this case .

[bmorcelli]

Probably the pinouts are not matching, as this module was released after Bruce..

Check the file brucePins.conf if the pins are right for your device, and change them accordingly..

You can enable devMode and change it in the firmware.. scroll the Main Menu to the right (Wifi-> BLE-> RF.... CFG-> Wifi....) 5 times without pressing Previous.. it will enable devMode

After that, CFG> Dev Mode> CC1101 pins> amd set them as needed..

After that go to RF> Config> RF Module> CC1101.. hopefully it won't get any error message