Migrating from Home Assistant's built-in integration

[AtmanActive]

Hi,

So I recently learned about this add-on and I am looking forward to trying it out.
However, I already have about 10 devices (all rockers) configured in the Home Assistant's built-in EnOcean integration (configuration.yaml).

Hence, I'm not sure how to proceed:

• Will the integration stop working when I run the add-on?
• Do I need to cut+paste my rocker configuration from the integration into the add-on?
• Do I need to remove the integration before I run the add-on?

in other words: is it possible to run both the integration and the add-on in parallel and do the migration slowly, or do I need to dismantle the integration fully and then recreate the whole thing in the add-on (only one may run)?

Thanks.

[ChristopheHD]

• Will the integration stop working when I run the add-on?

No, but the addon won't start as your integration is already using your EnOcean key.

• Do I need to cut+paste my rocker configuration from the integration into the add-on?

Integration and add-on does not have the same configuration scheme. Integration is YAML and addon is INI.

• Do I need to remove the integration before I run the add-on?

No, but you need to deactivate it.

is it possible to run both the integration and the add-on in parallel and do the migration slowly, or do I need to dismantle the integration fully and then recreate the whole thing in the add-on (only one may run)?

You cannot run both the integration and the addon in parallel because they can't use both the EnOcean key at the same time. Only one may run but you can keep both installed and activating one or another depending on the state of your migration.