Replies: 1 comment 1 reply
-
M555 P2 didn't work either. :-( |
Beta Was this translation helpful? Give feedback.
1 reply
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
-
I'm trying to see if I can get Octolapse to work with the Toolchanger. Not looking too good at the moment. I got this message...
"Printer Not Supported
You printer does not support a critical gcode, M114, which Octolapse uses to correctly time snapshots. You can solve this problem by flashing your printer with firmware that supports this gcode. I recommend you contact the manufacturer, since this gcode is required for many OctoPrint plugins, and is considered a standard."
Well... I know that RRF does support m114 so... any ideas or is it a no op?
Beta Was this translation helpful? Give feedback.
All reactions