unable to make it work...

[seblenor]

Hi , thanks for your job, however, i am absolutly unable to configure my keymap .
my project is a split dactyl manuform 6*7 using 2 pi pico.
As long as i try to configure a normal keyboard, it works like a charm, but i am unable to make it work for a split.
Actualy my wiring is good, (both halves work propoerly using 2 usb ports) but configuring it with a cable seems impossible to configure for me.
can you please explain the differents options i have to select to run it properly ?
actualy they are connected through gp 16 and 17 and fliped between the controlers (but ofcourse, i can change that !)

thanks !

[JanLunge]

There is a lot of things that could be an issue while setting up, i usually just try out all the split options and also check if things work if the other half is the main half, for some reason the side that is plugged in to usb is important when the split side detection fails i have not once seen someone figure out whats wrong its always a "oh now it works" this is something i want to improve but its complicated as at that step we dont get feedback from the controller until all pieces work. So check that both work independently and then swap the config to split and see when they show up in the logs of the other side (repl)