Display freezing after Filament Runout

[mosheas]

Hi, nice job, thank you, I think i fund some bug.. so after filament Runout Happens, and when park nozzle is time out, i change the filament , and reprint than happens. the Display gets freezing on message "Reheat Finished Press To Continue" , even though the printer continues to print. only turning it off and on again it's fixes the phenomenon.

[Jyers]

This is fixed in the latest release.

[mosheas]

Yes, thank you, is it's work fine, Your firmware works great, thank you very much.

…

On Tue, Feb 23, 2021, 17:27 Jyers ***@***.***> wrote: This is fixed in the latest release. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#101 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AHW7MCXZVJOGLK3D4BCG2ITTAPCNLANCNFSM4YA2CA6Q> .