ESP32-S3 support

[Geoide]

Hello.

What is the current support for esp32-s3? I have one but following the existing documentation, although I do load programs, I am not able to see anything in the xsbug console or interact with the board (for example, flashing an LED).

Thanks

[phoddie]

@Geoide – the ESP32-S3 port is working well, including xsbug support. There was an issue a while back, but it has since been resolved. I know of several developers that have succeeded in getting it to work. @mkellner may be able to provide some advice on what to check on your set-up.

[Geoide]

Thanks @phoddie

And... is there some way to get data from de new usb OTG port?

Thanks.

[mkellner]

Hello @Geoide, There are quite a few esp32s3 modules wired in a bunch of different ways. If you've got the Espressif ESP32-S3-DevKitM (or equivalent), there are two ports at the bottom. Connect to the UART port for loading programs to the board and running xsbug.

You may have to set the UPLOAD_PORT environment variable to the device path for the esp32s3. For example, when I plug in my esp32s3 into my Mac, there is a new entry in /dev - /dev/cu.usbserial-144340. I would then export UPLOAD_PORT=/dev/cu.usbserial-144340 before using mcconfig -d -m -p esp32/esp32s3.

[Geoide]

Thanks for your help @mkellner.

I meant the new USB OTG to connect my old gamepad and get the data from it in order to use it like a remote control. I didn't refer to the usual usb port to comunicate with the computer.

[mkellner]

@Geoide, I don't believe there is a project yet to build USB OTG modules.