gsoc-complete?

Author: RemZapCypher

gsoc-final-report.md

@@ -12,34 +12,34 @@
 
 82596 Network Interface Card
 ----------------------------
-[x] Monitor Mode
-[x] Timer
-[x] Bus Throttle
-[x] Promiscious Mode
-[x] Get 82596 Working on HPUX
-[x] Self test
-[x] Accurate CU and RU transition State
-[x] Reset Values
-[x] Linear Segmented and 82596
-[x] Support for Little endian mode
-[x] VMstate descriptors
-[x] Polling mechanism
+- Monitor Mode
+- Timer
+- Bus Throttle
+- Promiscious Mode
+- Get 82596 Working on HPUX
+- Self test
+- Accurate CU and RU transition State
+- Reset Values
+- Linear Segmented and 82596
+- Support for Little endian mode
+- VMstate descriptors
+- Polling mechanism
 
 What is still left:
-[-] RX and TX function (Note: RX and TX function is working for Linux, but not for HPUX 10.20)
-[-] Statistical counters (Paritially implemented)
+- RX and TX function (Note: RX and TX function is working for Linux, but not for HPUX 10.20)
+- Statistical counters (Paritially implemented)
 
 
 PRs:
 
 
 NCR710 SCSI Controller
 ----------------------
-[x] Design from ground up
-[x] Compatibiality testing as PCI Device from the WinUAE
-[x] Adding NCR710 support to Seabios, this was done hackishly as seabios primarily support PCI devices but ours is non-PCI device.
-[x] Adding LASI_NCR710 support to QEMU
-[x] Redesigned the NCR710 entirely from the linux kernel
+- Design from ground up
+- Compatibiality testing as PCI Device from the WinUAE
+- Adding NCR710 support to Seabios, this was done hackishly as seabios primarily support PCI devices but ours is non-PCI device.
+- Adding LASI_NCR710 support to QEMU
+- Redesigned the NCR710 entirely from the linux kernel
 
 PRs:
 
@@ -49,5 +49,4 @@ Final Result: Working NCR710 SCSI Controller for linux
 
 Future Work
 -----------
-- Add NCR710 Support for the HPUX 10.20: 
-This requires minimal work considering but have to iron out a few changes, it seems that the HPUX is currently facing kernel panic. I have added proper trace functions so it would be easier for me to debug the NCR710 and add HPUX 10.20 support.
+Add NCR710 Support for the HPUX 10.20: This requires minimal work considering but have to iron out a few changes, it seems that the HPUX is currently facing kernel panic. I have added proper trace functions so it would be easier for me to debug the NCR710 and add HPUX 10.20 support.