Точка входа в процедуру CreateDXGIFactory2

[benspinoza]

v1.0.18 при запуске пишет: "Точка входа в процедуру CreateDXGIFactory2 не найдена в библиотеке DLL dxgi.dll."
Не запускается. Win7x64

[darnn]

Have you tried any of this?
https://www.softwaretesttips.com/procedure-entry-point-createdxgifactory2-could-not-be-located/

[benspinoza]

I've tried to put dxgi.dll of different versions into the program folder, then tried the method with ReShade 5.5.2. No effect.

[darnn]

Can you remove it altogether? I don't have it at all...

[benspinoza]

Win7 does not allow to delete dxgi.dll. There are 6 versions of it in system folders
C:\Windows\System32\dxgi.dll
C:\Windows\SysWOW64\dxgi.dll
C:\Windows\winsxs\amd64_microsoft-windows-directx-dxgi_31bf3856ad364e35_6.1.7601.17514_none_98a47dc2352c4409\dxgi.dll
etc.

@benspinoza Are your GPU drivers installed properly? Try using dxdiag to check. (Click Windows+R and type dxdiag and press enter, go to screen and see what it says).

[rddim]

I have the same error on Win 7. Qt6 does not support Win 7.

[mara004]

I have the same error on Win 7. Qt6 does not support Win 7.

In that case, perhaps releasing an alternative build with Qt5 would be an option, if it's not too much work to set up?
If you had release automation, I'd guess it might be relatively simple to adapt, but it looks like there is no build script / GH workflow yet?

@mara004 I'm actually working on that. I also believe this is not a bug with ScanTailor, so I'll probably convert it to a discussion.