EdgeLab Getting Start with Seeed Studio XIAO ESP32S3 (Sense) | Seeed Studio Wiki

[giscus[bot]]

EdgeLab Getting Start with Seeed Studio XIAO ESP32S3 (Sense) | Seeed Studio Wiki

EdgeLab Getting Start with Seeed Studio XIAO ESP32S3.

https://wiki.seeedstudio.com/xiao_esp32s3_edgelab

[matsujirushi]

I tried the meter example.
Nothing is displayed on the LCD.

An error is output to the console.

I (639) camera: Detected camera at address=0x30
I (639) camera: Detected OV2640 camera
I (639) camera: Camera PID=0x26 VER=0x42 MIDL=0x7f MIDH=0xa2
I (709) s3 ll_cam: node_size: 3840, nodes_per_line: 1, lines_per_node: 8
I (709) s3 ll_cam: dma_half_buffer_min:  3840, dma_half_buffer: 11520, lines_per_half_buffer: 24, dma_buffer_size: 23040
I (709) cam_hal: buffer_size: 23040, half_buffer_size: 11520, node_buffer_size: 3840, node_cnt: 6, total_cnt: 10
I (709) cam_hal: Allocating 115200 Byte frame buffer in PSRAM
I (709) cam_hal: Allocating 115200 Byte frame buffer in PSRAM
I (719) cam_hal: cam config ok
I (719) ov2640: Set PLL: clk_2x: 1, clk_div: 3, pclk_auto: 1, pclk_div: 8
I (799) spi_bus: SPI2 bus created
I (799) spi_bus: SPI2 bus device added, CS=2 Mode=0 Speed=40000000
E (799) screen driver: Screen controller not supported or not enabled in menuconfig

Is the setting of menuconfig insufficient?

[matsujirushi]

GC9A01 driver check required.

Component config -> LCD Drivers -> Select Screen Controller -> GC9A01