timeout - reconnect

[CA1458]

Hello

I am successfully reading data from a Mitsubishi Q series via TCP, frame 3E.

At first I connect and then I read data every second. That works.

After a while I get a "timeout" message. Nothing works anymore.

Then: Disconnect and connect works for the connection, but then when I read data I always get a status ...read...timeout....

After a full deploy everything works again.

The control is always switched on at this time and can be reached via ping.

How can I solve this?

Thanks and best regards

[framatech]

Hello!
I have the same problem.
Have you already found a solution to this problem?
best regards!

[CA1458]

Hello! I have the same problem. Have you already found a solution to this problem? best regards!

Hello
I changed the protocol to UDP and after the change I had no problem since 3 months.

[framatech]

I tried UPD but I can't get a connection at all. I'm trying to connect to an FX3GE. Would you be kind enough to send your flow and a screenshot of the Melsec parameter of the interface. Thank you very much in advance. best regards

[CA1458]

I tried UPD but I can't get a connection at all. I'm trying to connect to an FX3GE. Would you be kind enough to send your flow and a screenshot of the Melsec parameter of the interface. Thank you very much in advance. best regards

[framatech]

These are my settings on the controller. 221 is the PLC 220 is NodeRed... i am thinking wrong here?

[CA1458]

These are my settings on the controller. 221 is the PLC 220 is NodeRed... i am thinking wrong here?

Sorry but I have no expertise of the programming/configuration of this controller.
I only made the NodeRed connection to the controller.

[framatech]

I understand. thank you for your time