Reset button on BTT Mini12864 not working with SKR-Mini_Screen_Adaptor on BTT SKR Mini E3 V3

[staticanime]

Current Behaviour: Pressing the reset button on the BTT Mini12864 screen does not do anything
Expected Behaviour: Pressing the reset button on the BTT Mini12864 should force an emergency shutdown of klipper

Current printer configuration is here, LCD config is near the bottom: https://github.com/staticanime/klipper-configs-voron-switchwire/blob/main/printer.cfg
It's a straight copy of the sample config from the repo, with the LED colors changed to my liking. Not sure if I'm doing something terribly wrong, but I've tried both with and without the JP1 jumper connected, I get no response from the reset button on the screen in either case. This was working previous when connected to a BTT Octopus in my Voron 2.4

[kellertk]

I was having this problem too. It's because the reset button on the BTT Mini12864 is connected to pin 8 of the EXP2 header, but the kill switch on FYSTEC is connected to pin 10. The STM32_Mini12864 board does not connect pin 8 according to the schematics. So here's what you need to do:

1. Bridge pin 8 and pin 10 of the EXP2 header on your STM32_Mini12864. I did this with a blob of solder. Maybe a wire would work.
2. In your config, set your config to include a kill_pin with an internal pull-up, like this:

[display]
lcd_type: uc1701
kill_pin: ^!menu:PF0
spi_bus: spi1
cs_pin: menu:PA4
a0_pin: menu:PA2
rst_pin: menu:PA3
contrast: 63
encoder_pins: ^menu:PA0, ^menu:PA1
click_pin: ^!menu:PB1
[neopixel btt_mini12864]
pin: menu:PA13
chain_count: 3
color_order: RGB
initial_RED: 0.2
initial_GREEN: 0.2
initial_BLUE: 0.2
[pwm_cycle_time speaker]
pin: menu:PF1
value: 0
shutdown_value: 0
scale: 1