Question for CAN-FD (Bit rate switching)

[etaParkJh]

Hello,
While testing CAN and CAN-FD, I confirmed that both CAN and CAN-FD are working properly. However, when Bit Rate Switching (BRS) is enabled in CAN-FD, the message is not received.
I’m wondering if this issue could be addressed in the next update.
I'm very satisfied with the product.
Thank you.

[Nakakiyo092]

Hello,

I could transfer a CAN FD frame with BRS enabled using the latest firmware (1.0.0.3).
I suppose there was an issue in your setup.

While testing CAN and CAN-FD, I confirmed that both CAN and CAN-FD are working properly. However, when Bit Rate Switching (BRS) is enabled in CAN-FD, the message is not received.

I had similar situation when I used improper bit timing setup.
I would suggest to check your bit timing setup of USB2CANFD and the other device.
The timing can be modified with Sddxxyy[CR] and Yddxxyy[CR] and should be same as or at least close to the other device on the CAN bus.

Regards.