The following changes affect module playback critically. In some cases, you need to modify modules.
- Before BambooTracker v0.3.0, square-masked saw and square-masked inversed saw were not actually square-masked.
- In BambooTracker v0.2.1, the start position of effect sequence when declaring sequence type effect after key on was changed from 2nd to 1st.
- In BambooTracker v0.2.1, execution routine of pattern effects is revised. Some effects (especially delay effects) may behave differently than before.
- Since BambooTracker v0.2.0, a bug is fixed that increases tone by octave when changing from SMTri (previous: Tri w) to Saw in SSG waveform sequence.
- Since BambooTracker v0.1.5, a bug to set wrong value of FM envelope in instrument event is fixed. You would need to change TL3 value if you use AL = 0-4 to play module made by before v0.1.4 correctly.
- Since BambooTracker v0.1.4, FM octave range lower. However the tracker automatically correct song octaves whose module version is before 1.0.2, old octave 7 cannot be played.
- Since BambooTracker v0.1.3, FM synthesis frequency is changed from 110933Hz to 55466Hz.
And the found critical bugs about file I/O.
- In BambooTracker v0.2.0, there is the bug that unit subdata of FM operator sequence is not omitted when saving a module and an instrument. To read them made by v0.2.0 and used operator sequence, please use the fixed version tracker.