How to change the M_Bus-Adress of a device? #32
-
|
How to change the M_Bus-Adress of a device (Sensorstar-U) when I have more than one use and they are all on 0? |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 6 replies
-
|
Go to the GUI, there is a link to the change page. Only one slave should connected. But, there was a failure at the Nano firmware. Use the new .bin file, not the release zip. I have to release it new. Only Nano was effected. |
Beta Was this translation helpful? Give feedback.
-
|
Are you talking about the WebGui? I have the latest .bin (src/MBusino/build/esp32.esp32.lolin_s2_mini/MBusino.ino.bin) but I don't see a link. Only the GUI and beneath is "Update" and "MBusino" |
Beta Was this translation helpful? Give feedback.
-
|
OK, I got it, it's only with the src/MBusino5S/build/esp8266.esp8266.d1_mini/MBusino5S.ino.bin |
Beta Was this translation helpful? Give feedback.
-
|
haha, just ran into this as well... was already looking into whether setting the address via 254 broadcast may not be supported by my mbus module. this was a quick fix then. |
Beta Was this translation helpful? Give feedback.
-
Please explain your problem and your solution. Your meter doesn't accept broadcast? |
Beta Was this translation helpful? Give feedback.
-
|
I was just using the firmware from release section which had the bug in. tried to change the address without success. with the current firmware from the main branch everything is working |
Beta Was this translation helpful? Give feedback.
-
|
:-) yes, you need the 5S Firmware. With the single slave Firmware is no need to change the address. :-) |
Beta Was this translation helpful? Give feedback.
-
|
da is was dran ;) Na ja, Morgen erstmal den Wärmemengenzähler richtig rum einbauen, vielleicht kommen dann auch sinnvolle Ergebnisse..... |
Beta Was this translation helpful? Give feedback.
:-) yes, you need the 5S Firmware. With the single slave Firmware is no need to change the address. :-)