CHIP stuck in FEL mode

[phatina]

Description
Having built an image using your layer meta-chip, I can flash CHIP, but after successful flashing, it remains in FEL mode every time I power it on.

Steps to reproduce the issue:

1. Connect FEL pin with ground.
2. UBI_IMAGE=chip-hwup-image-chip.ubi ./flash_CHIP_board.sh
3. Disconnect FEL pin and power off/on the device

Describe the results you received:
Device is always in FEL mode with or without jumper wire between FEL pin and ground.

Describe the results you expected:
Normal boot.

Additional details (revisions used, host distro, etc.):
I built the image on Fedora 25.

[ArnaudNe]

I have the exact same issue. Did you manage to solve this on your own ?

Test setup

• Ubuntu 16.04 & 17.10
• Yocto (rocko-2.4.1)
• meta-chip (master)
• meta-sunxi (master)
• Tested on both of my C.H.I.P (not Pro)

Compilation is successful, flashing looks successful too, but the CHIP is stuck in FEL mode (I can reflash it without having to plug the jumper-cable).

I used a FTDI to monitor the serial port, but with no success, no output when I plug the power on after flashing it (Although I can see output when I flash the device)

I also tried to compile images with the following branches

1. Pyro

• Yocto (pyro)
• meta-chip (pyro)
• meta-sunxi (pyro)

2. Morty

• Yocto (morty)
• meta-chip (master)
• meta-sunxi (morty)

But the compilation fails.

Thanks in advance

[phatina]

Hi, no luck so far.