0.4.1g

[alienatedsec]

Breaking changes !!!

• There is a new baseline 0.4.1g, so you need to prepare your SD card for it - follow Specifics of the yi-hack-v5 firmware and flashing #267
• The camera web page is no longer under port 8080 but it is back to default port 80 - access your camera web page using its IP only. Those with proxy environments or Home Assistant integrations need to amend their settings.
• The new baseline is needed to fix OTA upgrades OTA FW upgrade shows no value for "Available:" #326 - cameras on 0.4.1e and 0.4.1f can upgrade from the WebUi if the SD card is still FAT32 - future non-baseline upgrades will be released without this requirement.
• We need testers, so if you have no physical access to your camera - don't upgrade, as it may require fixing by downgrading etc.

What's Changed

• Fix for yi_home and yi_dome - the wpa_supplicant upgrade in the baseline image was prevented by the YI upgrade of an older file
• Recovered lost system.sh upgrades and other functions
• Cleared the libs folder on the home partition - attempt to fix Rootfs corruption after a few months - bootloop #312 and Boot Loop Investigation #291

What is still not working

• [0.4.1e] No timestamp watermark on stream #336 - unable to find the right sleep settings as suggested by @roleoroleo - please test and suggest if possible - it does not work on my cameras whatever I try - yi_home_1080p - 48US and yi_dome - 43US
• MQTT status changes many times per second (offline/online) when RTSP server is activated (0.4.1.e) #333 - Still investigating the MQTT status changes

Full Changelog: 0.4.1f...0.4.1g

---

This discussion was created from the release 0.4.1g.

[fraserp]

Installed and working - also the interface on my Yi outdoor seems way snappier/more responsive than before (not sure if that is due to intentional change)

[alienatedsec]

Please follow #312 as the boot looping is still the case for v0.4.1g