0.4.1j - Release Candidate

[alienatedsec]

Breaking changes !!!

• This is a release candidate as the major issues are fixed
• There is a new baseline 0.4.1j, so you need to prepare your SD card for it - follow Specifics of the yi-hack-v5 firmware and flashing #267 and this guidance Pre-Release Versions #248
• The camera web page is no longer under port 8080 but back to default port 80 - access your camera web page using its IP only. Those with proxy environments or Home Assistant integrations must amend their settings.
• The new baseline is needed to fix OTA upgrade OTA FW upgrade shows no value for "Available:" #326 - cameras on earlier versions cannot upgrade from the WebUi as there is an additional baseline check - it refers to 0.4.1 for the latest release - 23a96a5 - amend the file on your SD with your baseline version to bypass this check and upgrade via WebUI or copy the file over and change its name as per the guidance in Pre-Release Versions #248
• Future non-baseline upgrades will be released without SD formatted to the FAT32 requirement.
• We need testers, so if you have no physical access to your camera - don't upgrade, as it may require fixing by downgrading etc.

What's Changed

• Improve MQTT by @Minims in Improve MQTT #349 - please test if working as intended
• Fixed WiFi scan page
• wpa_supplicant upgrade logic
• Reduced busybox_tools size on the SD

What is still not working

• Pure WPA3 networks - recommending WiFi's with WPA2 - if you know that your camera worked with WPA3, please let me know in the release discussion so we can investigate further. I managed to run on a mixed WPA2/WPA3, and it may not be the case for others.
• Some MQTT and HA-related settings - e.g., IR seems not to be responding - need to be reviewed as mentioned by @roleoroleo in Improve MQTT #349 (comment)

Full Changelog: 0.4.1i...0.4.1j

---

This discussion was created from the release 0.4.1j - Release Candidate.