Error in Software Serial Documentation - halfBitDelay should be placed before if (low) check [MKC-558]

[frami75]

Issue arduino/Arduino#1315 is not yet solved.
A description of the error can be found here:
arduino/Arduino#1315 (comment)

It refers to the Serial Tutorial:
https://www.arduino.cc/en/Tutorial/SoftwareSerial

[matthijskooijman]

Agreed that the code does not match the text, and I think the code is not entirely correct either. Ideally, you sample halfway each bit time, which the code does not do. The implementation suggested in arduino/Arduino#1315 seems better, since it also stays waiting for a start bit when noise is received (instead of returning an undefined value as the code in the tutorial does). For clarity, I think the full code should be:

int SWread()
{
  byte val = 0;

  //wait for start bit
  while (true) {
    while (digitalRead(rx));
    // Sample again halfway through the start bit
    delayMicroseconds(halfBit9600Delay);
    if (digitalRead(rx) == LOW)
      break;
  }

  delayMicroseconds(halfBit9600Delay);
  for (int offset = 0; offset < 8; offset++) {
   delayMicroseconds(bit9600Delay);
   val |= digitalRead(rx) << offset;
  }
  //wait for stop bit + extra
  delayMicroseconds(bit9600Delay); 
  delayMicroseconds(bit9600Delay);
  return val;
}

I have not tested this. @frami75 if you are working with this code, maybe you could test the above to confirm it is correct?

[frami75]

I'm sorry, I have no possibility to test this code. I have no experience in Arduino programming and stumbled over it when searching for information about programming of serial communication.
I was only confused, as the code didn't match the description, but as it was a topic here some years ago I was convinced, that it's really a bug.
Hopefully there is someone who can make the correction.