Auto-Conf

[VPetras]

PROBLEM DESCRIPTION

A clear and concise description of what the problem is.
When flashing latest fw (14.6.0) via webinstaller on device Sonoff THR320D. I tried set auto-conf "Sonoff THR320D with DS18x20" and it showed me its need to be restarted. After restart it doesn't connected back to wifi and i need to power the device off and then power on. It doesn't load the configuration and stayed on "ESP32-Devkit"

REQUESTED INFORMATION

Make sure your have performed every step and checked the applicable boxes before submitting your issue. Thank you!

• Read the Contributing Guide and Policy and the Code of Conduct
• Searched the problem in issues
• Searched the problem in discussions
• Searched the problem in the docs
• Searched the problem in the chat
• Problem is not scripter related, in this case open a discussion and tag gemu2015
• Device used (e.g., Sonoff Basic): Sonoff THR320D with DS18B20
• Tasmota binary firmware version number used: 14.6.0
  • Pre-compiled
  • Self-compiled
• Flashing tools used: _____
• Provide the output of command: Backlog Template; Module; GPIO 255:

  Configuration output here:

• If using rules, provide the output of this command: Backlog Rule1; Rule2; Rule3:

  Rules output here:

• Provide the output of this command: Status 0:

  STATUS 0 output here:

• Set weblog to 4 and then, when you experience your issue, provide the output of the Console log:

  Console output here:

TO REPRODUCE

Steps to reproduce the behavior:
Flash sonoff
Connected to wifi
Selecet "Sonoff THR320D with DS18x20" in auto-conf and confirm restart
After the problem shows up and adter restart it doesnt connect back to wifi and need to manualy power off and power on

EXPECTED BEHAVIOUR

A clear and concise description of what you expected to happen.
After auto-conf the template should loads up

SCREENSHOTS

If applicable, add screenshots to help explain your problem.

ADDITIONAL CONTEXT

Add any other context about the problem here.

(Please, remember to close the issue when the problem has been addressed)

[s-hadinger]

There are many possible reasons. Can you attach a serial connection to get the logs?