RF 433 might be incorrect in ESPHOME config

[dmshimself]

The ESPHOME config has pin 17 for the RF receiver, but I cannot get that to work with a known good remote, even with dump: all.

But the pinout page on the web site has pin 16 for RF in and pin 17 for RF out. Which is correct and is RF out for transmitting implemented?

[tarontop]

There is no problem with our GPIO configuration

[dmshimself]

Thanks for confirming your understanding. My relay will not receive RF on the GPIO 17 that is defined in your standard ESPHOME config, but works fine with pin 16 which is also the pinout on the web site description for this device, so it would be worth a double check, but that is up to you of course.

Can you also confirm if RF transmission is supported and if so on which GPIO?

For other people who cannot get a known good RF remote to work, try GPIO 16 and I also found that it was necessary to change the GPIO config to include, tolerance, filter and idle. In my case I used the following, but your rig might need to be different.

remote_receiver:
pin: GPIO16
dump:
- rc_switch
tolerance: 50%
filter: 10us
idle: 9ms