How is the low profile wireless case assembled

[coredump]

I keep looking at it and can't figure out how the bottom is secured to anything else on the wireless low profile case.

[azhizhinov]

Hello. Sorry for delay.
Well, didn't printed that case. I suppose, the autor, has planned to use double sided sticky something for the bottom part. The bottom part just sticks to the PSB. The middle part is ankored with the switches itself and uses magnets to hold the top part.

[coredump]

yeah. That's the only way I can think about too. Maybe @yungcheng is around to answer

[yungcheng]

hello, the top plate and mid section can be connected with magnets, the bottom plate is designed to friction fit to sockets (the cutoffs should fit sockets and create a tight fit, no screws nor magnets are needed)

[yungcheng]

[coredump]

oh that definitely didn't work here, probably some hole compensation or tolerance issue. In any case thanks for the info. If you have the step or source file floating around it would also be nice to have but thanks anyway!

[coredump]

ok it can kinda work but the tolerances have to be spot on. Also since I am using through hole diodes the solder bumps on the bottom prevent it from touching. I tried shaking it a little to put in a bag and the bottom plate fell off lol.

[yungcheng]

@coredump step file is uploaded in #10
@azhizhinov could you help review & merge the PR please? Thanks in advance!