Baremetal demo on NXP iMX8QM

[Gcaptz]

Hi, I'm interested in trying bao hypervisor to virtualization on NXP iMX8QM. However, the board I use is the toradex Ixora Apalis iMX8QM board not the iMX8QM-MEK board from NXP. I think the two have similarities even though not in their entirety so that the documentation on bao that supports iMX8QM can still be relevant.

I have a problem booting the bao that I don't know what the stuck condition means.

I have tried to use the configuration of 2 versions to run this baremetal demo. first with the original from the bao documentation and second with the firmware changes that I adjusted to toradex (so in the firmware build step I am completely based on toradex documentation). why I adjusted the firmware, maybe the boot failure is due to the incompatibility of the firmware used. from both versions that I have tried, produce the same results. I also changed the address of the UART to adjust but the results are also the same.

Is there anything I need to pay more attention to for booting bao on this device?

Best Regard,
Azka

[DavidMCerdeira]

Greetings,

I'm not exactly sure what could be wrong.
I'm busy at the moment, but within the following weeks I'll try to replicate the steps on our iMX8QM platform.

I'll let you know if I find something.

Best regards.