[FEATURE] Monitor Volume Control

[rantwhy]

When connecting to a WING with the latest firmware 3.0.5. companion will show the yellow triangle and say Waiting for status. It will never give the green OK. Furthermore, on the buttons, you will get yellow squares indicating that there is a connection problem. you can still receive and send commands to the WING however, they can be delayed up to two minutes as you start an initial connection. once connected and after about 2 minutes pass you still have a yellow triangle and square indicating that there is a problem but you can control as normal.

I assume there is some preamble information that companion is waiting for that it is not receiving and that is hindering the flow of the rest of the initialization.

I have 2 of the WING consoles and they have the same problem. Im happy to test any improvements. Thanks

[elliotmatson]

Hey @rantwhy! This module is being completely rewritten for Companion v3, you can find more details on #28!

[rantwhy]

@elliotmatson Wonderful, I look forward to the update. If you need a tester, I have a couple of these consoles. As a side note, is it possible to control the headphones and monitor output volume. I understand they are the only non-encoder volume controls but I have a couple of use cases that I would like to remote the overall volume for the studio area. but I did not want to sue a mix main or matrix. Thanks

[janikwitzig]

Hi @rantwhy, it looks like you‘re right and there is no way to control the monitor volume for the full-size console. It says so in the OSC Doc from Behringer on page 29 as a footnote for the /cfg/mon/1/$lvl command. It can still be implemented for the other versions.

[janikwitzig]

I added the command but was unable to test so far.