Meshes alignment failure

[arv8315]

Similar to what has been reported outside this discussion forum, also experienced the same issue; “ I have two meshes that I'm trying to align in MeshLab but can't for some reason. I've used "point based gluing" and chose (in may case 10 pairs). The meshes align almost, but I cannot get it to process.

The failure is: "Failure. No successful arc among candidate Alignment arcs. Nothing Done."

I will try to find the source code for this and keep trying to solve it. Otherwise , stuck here atm. Any suggestions?

[arv8315]

if one of the meshes in the pair has a lower quality (eg: noisy or incomplete or slightly distorted), pressing Process fails for me. If this is not the case, it works from my experience. So the question is perhaps about how to ensure both meshes have an adequate quality standard? So far, changing the parameters of this tool did not help much without upgrading anything else.

[stale]

This issue has been automatically marked as stale because it has not had recent activity. The resources of the VCLab team are limited, and so we are asking for your help. If this is a bug and you can still reproduce this error on the last release of MeshLab, please reply with all of the information you have about it in order to keep the issue open. If this is a feature request, and you feel that it is still relevant and valuable, please tell us why. This issue will automatically be closed in the near future if no further activity occurs. Thank you for all your contributions.