sdwcap never loads pre-calculated tapers

[AlainPlattner]

On line 84, the "if exist" statement has an " & 1==3", which is always false.

Is there a reason why we still have the loading "turned off", or can we enable loading?

[fjsimons]

Fixed it! On the plane to Belgium. 2018-03-30 21:10 GMT-04:00 Alain Plattner <notifications@github.com>:

…

On line 84, the "if exist" statement has an " & 1==3", which is always false. Is there a reason why we still have the loading "turned off", or can we enable loading? — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#17>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AGfGqG0ZE3RWxKnVn0VCSBWYiidIDUwHks5tjteGgaJpZM4TCRuL> .

-- Frederik J Simons www.frederik.net

[AlainPlattner]

Thanks. Have fun at EGU!

The load still only happends when you don't want to store all tapers (vcut>0). What is the reason for this? I usually set vcut =-1 to make sure I get all tapers. Shall we remove this additional constraint for the loading?