Dual status APC Smart-UPS

[ASergeyV]

The script doesn't detect dual statuses for the APC Smart-UPS. For example, when a battery needs replacing and the system is running on AC power, the status field displays "ALARM OL RB," and this value is not processed. Is it possible to modify the script to check whether the field contains a specific value (not "equal") and process them based on severity?

[ASergeyV]

How I did it in ups_status.sh:

case "$state" in
        *"LB"*)         echo 3 ;; #'Low battery' ;;
        *"OB"*)         echo 2 ;; #'On battery' ;;
        *"RB"*)         echo 4 ;; #'The battery needs to be replaced' ;;
        "OL")           echo 1 ;; #'On line (mains is present)' ;;
        "CHRG")         echo 5 ;; #'The battery is charging' ;;
        "DISCHRG")      echo 6 ;; #'The battery is discharging (inverter is providing load power)' ;;
        "BYPASS")       echo 7 ;; #'UPS bypass circuit is active echo no battery protection is available' ;;
        "CAL")          echo 8 ;; #'UPS is currently performing runtime calibration (on battery)' ;;
        "OFF")          echo 9 ;; #'UPS is offline and is not supplying power to the load' ;;
        "OVER")         echo 10 ;; #'UPS is overloaded' ;;
        "TRIM")         echo 11 ;; #'UPS is trimming incoming voltage (called "buck" in some hardware)' ;;
        "BOOST")        echo 12 ;; #'UPS is boosting incoming voltage' ;;
        "OL CHRG")      echo 13 ;; #'On battery (mains absent) and the battery is charging' ;;
        "OB DISCHRG")   echo 14 ;; #'On battery discharging (mains absent)
        * )             echo 0 ;; #'unknown state' ;;
    esac