Update de Code

[rafaelalvesferreira]

Hello guys
I'm trying to implement your project in two arduino nano (atmel 328p).
My intention is to tone a buzzer when the receiver is insider de loop.

I know that there are some time you don't update this project, but as I'm far from beeing a expert in this I could use some help.

By compiling the code you posted here the arduino IDE is telling that I have to update an library (signal.h) to interrupt.h

I've already assembled as you mention on the website but i had no sucess in making it work.

Could you help me?
Best regards

[dzlonline]

Hi, I updated the lib with the change you mentioned. Can you send me a picture/schematic of your set-up.. Dzl

…

On Tue, Jun 6, 2017 at 6:35 PM, rafaelalvesferreira < ***@***.***> wrote: Hello guys I'm trying to implement your project in two arduino nano (atmel 328p). My intention is to tone a buzzer when the receiver is insider de loop. I know that there are some time you don't update this project, but as I'm far from beeing a expert in this I could use some help. By compiling the code you posted here the arduino IDE is telling that I have to update an library (signal.h) to interrupt.h I've already assembled as you mention on the website but i had no sucess in making it work. Could you help me? Best regards — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#2>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AD9xSPaiyF3B_uI4HweSoP3LQH0SJwPkks5sBX_jgaJpZM4NxmqA> .

[rafaelalvesferreira]

Hi, tks for the quick answer

This is the sender, I uploaded the simple transmitter code. I welded a socket to a 12v battery.
The wire is connected to Pin D9 and A4.

These image below are from the receiver.
I uploaded the code below to it:

#include <magloop_rx.h>

void setup()
{
Serial.begin(19200);
magLoopRX.begin();
pinMode (8, OUTPUT);
}

void loop()
{
digitalWrite (8, LOW);
if(magLoopRX.available())
digitalWrite (8, HIGH);
}

---

Even if the transmitter is powered off the led keep blinking

My assembly is not that fancy :)
I bought the components and assembled as the in the website.
The negative pole of the capacitor can`t be seen on the photo but ir on the right position.
I have a blue led wired to the pin D8.

Thank you again for the support.