Firmware v2.35 - Continuous Crash and Reboot After Power Cycle

[CodeKibbut]

1. Turn off the radio
2. Turn it back on
3. The system starts crashing and rebooting repeatedly

I attached the flash dump (changed from bin to txt)

1020ba591df0_0x000_0x10000_20260520_184840.txt

Information:
AMNVOLT V3S
ESP32-S3-WROOM-1-MCN16R8

[max-arnold]

The boot loop you described sometimes happens with all firmware versions. My recommendation is to try resetting the settings (press and hold the encoder, then power on the receiver)

Also see this if you have Wi-Fi enabled: #307

[CodeKibbut]

Hi
I already performed a factory reset (held the encoder while powering on), and Wi-Fi is disabled in the settings. Unfortunately, the issue still occurs - turning the radio off and back on causes the device to enter a crash/reboot loop.

I rolled back to v2.33, which was my last before the update.