One-Shot mode not working? #5
Description
I have the MCP3561 ADC but i only got i working with MCP3561_CONFIG3_CONV_MODE_CONTINUOUS command. When i try MCP3561_CONFIG3_CONV_MODE_ONE_SHOT_STANDBY i got 1 value but i can not get another one. Probably have the wrong settings but i have no idea wat i did wrong.
My config
```cmd[0] = MCP3561_CONFIG0_WRITE;
cmd[1] = MCP3561_CONFIG0_CLK_SEL_EXT; // clock selection
cmd[1] |= MCP3561_CONFIG0_ADC_MODE_CONV; // standby or converting
cmd[1] |= MCP3561_CONFIG0_CS_SEL_NONE; // input current
_MCP3561_write(hspi, cmd, 2);
cmd[0] = MCP3561_CONFIG1_WRITE;
cmd[1] = MCP3561_CONFIG1_OSR_20480; // over sampling rate MCP3561_CONFIG1_OSR_20480
cmd[1] |= MCP3561_CONFIG1_AMCLK_DIV8; // sampling clock prescaler
_MCP3561_write(hspi, cmd, 2);
cmd[0] = MCP3561_CONFIG2_WRITE;
cmd[1] = MCP3561_CONFIG2_BOOST_x1; // Boost
cmd[1] |= MCP3561_CONFIG2_GAIN_x1; // Gain
cmd[1] |= MCP3561_CONFIG2_AZ_MUX_ON; // offset cancellation algorithm
cmd[1] += 3; // last two bytes must always be 11
_MCP3561_write(hspi, cmd, 2);
cmd[0] = MCP3561_CONFIG3_WRITE;
cmd[1] = MCP3561_CONFIG3_CONV_MODE_ONE_SHOT_STANDBY; // conversion mode
//cmd[1] = MCP3561_CONFIG3_CONV_MODE_CONTINUOUS; // conversion mode
cmd[1] |= MCP3561_CONFIG3_DATA_FORMAT_32BIT_CHID_SGN; // SPI output data format, (32 and 24 bit available)
cmd[1] |= MCP3561_CONFIG3_CRCCOM_OFF; // CRC
cmd[1] |= MCP3561_CONFIG3_GAINCAL_OFF; // gain calibration
cmd[1] |= MCP3561_CONFIG3_OFFCAL_ON; // offset calibration
_MCP3561_write(hspi, cmd, 2);
cmd[0] = MCP3561_IRQ_WRITE;
cmd[1] = MCP3561_IRQ_MODE_IRQ_HIGH; // IRQ default pin state
cmd[1] |= MCP3561_IRQ_FASTCMD_ON; // fast commands
cmd[1] |= MCP3561_IRQ_STP_ON; // start of conversion IRQ
_MCP3561_write(hspi, cmd, 2);
cmd[0] = MCP3561_MUX_WRITE;
cmd[1] = (MCP3561_MUX_CH_AGND << 4) | MCP3561_MUX_CH0;
_MCP3561_write(hspi, cmd, 2);