SUBGHZ: Failed to start raw sniffer.

[buddylove1986]

i am using a Esp32-s3-n16r8 every time i run decode or replay i get Failed to start raw sniffer. i have checked all my wire using the default wiring.

[fdufnews]

Did you use the WebFlasher to program your devkit or did you generate your own firmware by compiling the code from the repository?

I tryed both and had no error with sniff or decode. I cannot test replay as I have nothing to replay.

If you have generated your own firmware, are you sure you selected the right environment?

If you mess up with the wiring, at the end of the config step you've got the message

❌ Failed to detect CC1101 module. Check wiring.

[buddylove1986]

I used the web flasher and I chose esp32-s3-n16r8 at the end it's successfully flashed I plugged it into the USB side and installed the drivers for serial and opened up connection and was greeted with the bus Pirates logo choose a mode or type help I type mode then 19 for subghz I used the wiring diagram that appears on the screen when you enter subghz I tried changing gdo0 from pin 14 to pin 9 I also try pin 8 with no change every time I try to run decode or replay I get the error failed to start raw sniffer scan seems to work and shows signal strength sweep seems to work I just can't replay or decode.

[fdufnews]

I did the same things as you and had no problem with decode.
Providing that the really same code as yours works as expected on my hardware and that other variants of the code (which are using the same code for the CC1101) works on other hardwares, I would be inclined to suspect a problem in the wiring or in the CC1101 module.
I cannot help more, may be @geo-tp has a different point of view.

[buddylove1986]

I will double check my wiring tonight and make sure it's wired correctly if that don't work I already ordered another cc1101 module off of Amazon and it'll be here tomorrow I'll try that maybe I just got a bad one other than that I just don't know thank you for your help though I do appreciate it.