Getting LogicAnalyzer 6.0 working!

[underwurlde666]

As usual I find myself going around & around in circles!

Hardware: LogicAnalyzer v6.0 PCB using a PICO2W device.
Firmware: logic-analyzer-firmware_v6.5.1_BOARD_PICO_2_W_WIFI.uf2
Software: logicanalyzer_6.5.0-win-x64
Python: python-3.12.9-amd64
Sigrok: Sigrok cli x86 64bit installer [20250318].exe
O/S: Windows 10

After much frustration (due to Python), LogicAnalyzer_6.5.0 starts up without any error messages and I can detect and connect to my hardware via USB.

HOWEVER

If I try to set up any kind of capture, I get the following error message pop-up after pressing 'Accept' in 'Capture Settings':
'Device reported error starting capture. Restart the device and try again.'

I cannot get past this point. (How is the device 'restarted' exactly?)

I think this may be something to do with the Sigrok drivers which I have installed on my PC but not entirely sure if they are actually being used if that makes sense?

Any help or pointers much appreciated!

Regards,

Andy

[gusmanb]

Can you send an screenshot of your capture settings?

[gusmanb]

Really glad it worked :)

[p3t3rm0v]

same issues here, can not load propertly 6.5 alwys stucked on sigrok installation (even same installation as underwurlde666 ). Any tip?

[p3t3rm0v]

Solved. I reinstalled 3.12.9.
Thanks

[smit7ua]

i have same problem

[smit7ua]

reinstal python dont help

[bluehunt25]

Hello, I got a board but I can't use it. Please teach me how to install it. I have a problem here.