Mode control - how?

[mgaman]

How can I set modes 0-3? From what I see on the screen SCLK polarity is always Idle at 0.
There are no instructions as how to change it

[jamesbowman]

Yes, that is correct. SPIDriver only runs in mode 0.

What device do you have that runs in another mode?

[mgaman]

I don't, yet but do anticipate in the near future.
Can it be changed via the serial connection or is it hard wired in the device firmware?

[nicktramp]

I was looking to use SPIDriver with the Melexis MLX90393, which uses SPI mode 3. Are other modes planned? I would offer to help implement, but I've never encountered Forth outside this project, so I'm afraid I wouldn't be much help...

[movingfox]

I can see that it's hard to be done because the firmware needs to drive st7735s at SPI mode 0 as well. Could you release a 'blind' version of firmware for those who'd like to have spidriver2 mode selection ? That seems to be a dirty but quick fix.

By the way, the file cal-b3.fs is missing in the firmware folder. Could you upload it?