Can I change the x5 in sen2 to x10?

[kukudemajia]

Can I change the x5 in sen2 to x10? If so, how can I change it? Thank you, looking forward to your reply

[Gouster4]

Adding resistor in series with positive probe.
I used 10Mohm+133Mohm (in paraller to get about 9.3Mohm result) in series with CH1.
I guess it would be same for added CH2, just different resistor. When going from x5 to x10, you would need to get its internal resistence just add same resistence in series. (If i ternal is 5MOhm, you would need to add 5Mohm in series. Then in code multiply value by 2 before displayng to match readings (in case you want it permanently built into scope.

For me, my x10 pprobe is addon (i built it into bnc male and bnc female connector),
So it just divides input by 10. So i have about 5V reading with 50V input voltage, so i dont mind multiplying reading by 10 by myself.