Home

Introduction

Hyperloop is passenger transportation system for travelling through evacuated tubes my means of passenger pods. The tubes system with all stations and pods have to be build by the players.

The pods can reach a maximum speed of up to 900 km/h. This requires a tube system on almost one level. The tubes can only be laid with a maximum slope of 2%. In addition Hyperloop provides an elevator system to reach the station in the underground or in the air, depending on the tube level.

To build a first route with 2 station, craft and place two Hyperloop Station Cores and connect them by means of Hyperloop Tube blocks.

To active the station for the first trip:

• Give both stations a unique name by right-clicking on the Hyperloop Junction Block (below the seat)
• Craft and place Booking Machines nearby both station. The Booking Machine has to get the same station name as the Junction block. That's it for now.

Some additional facts:

The tube route is automatically protected. You can dig only the ends of a tube line (head blocks). The junction block / station has to be protected manually.

A Junction block, which is the basis for a station, can have up to four tubes. That means you can build complex networks of tube lines. Each junction/station can be reaches from each point with one trip.

Build the pod around the seat according to the following picture. To get the best illusion of traveling, it is important that all pods are look the same from the inside.

For traveling you have to use the Booking Machine to select you destination. After booking, the pods (departure and arrival) are reserved for 20 seconds to start the trip. For starting the trip you have to use the Pod Seat. You will be placed on the seat and the door will close automatically.