v1.15.0-develop.10: Testing Needed Before Full Release!

[kneave]

v1.15.0-develop.10 is available, barring show-stoppers it'll be the last pre-release before I publish it to production.

I has a whole host of updates to the UI since the 1.14 release, the graph system has been replaced with a new timeline mechanism which works on mobile. It's not perfect but there will be a 1.15.1 and other releases to add further improvements.

If folks could jump on this one so I can squash any major bugs I'd appreciate it!

[mavoIn]

Hi @kneave,

first of all, thank you very much for developing this app!

Some small improvements / ideas from my side regarding to the dev-version 10:

• Currently, the 'Instructions' are displayed in every group. Perhaps it would be sufficient to show them just once within or below the 'Settings'?

• In the 'Profile Editor' you use an 'X' icon to delete a profile. To me, an X typically suggests closing a window, so a trash bin icon might be more intuitive—especially since you use the X for closing in other views."

• In the Profile Editor I can click through the nodes, but the editor for editing the selected node does not open below.

Best regards,
mavo

[kneave]

I've created a shit list to collate all the feedback so I don't forget something. There's a lot of functionality I added that others requested that I never use so I struggle to remember what needs checking

[mavoIn]

I had some more issues for your shit list ;-)

• the app is not working in the companion-app
• I had some trouble with reactivating HVAC-Mode to heat after switching it of the day before

Best regards,
mavo

[kneave]

Is it not working at all in the companion app or just a bit of a crap experience? I'm aiming for the latter for the initial release so the timeline is at least usable, then planning on tidying up the UI over time.

Regarding the latter, I've added it to my list to test but I have a feeling I fixed that as part of something else to be included in the .11 release. I was testing with one of my AC units and it wasn't coming on at all, I've just set the AC in my office to turn on to heat at 1215 (a few minutes from now) so will be able to tell you soon if that's the case

[kneave]

AC started heating fine, I've set a schedule of off and heat cycling for the next hour. I've become brutally aware of the different behaviours of thermostats around the world since starting this project so I know your millage may still vary but if it still doesn't work with .11 we know we're a good base to start from at least.