Hi,
I finally got my RP2W to work with the LIN UART converter and was able to switch on hot water, switch off, see CP-Plus time in Status page etc. This works fine.
MQTT is also set up (server is a Cerbo GX), and test number messages from the RP2W ("Send MQTT test message") show up in my MQTT explorer connected to the Cerbo GX. Also, all information from the Victron ecosystem is published on MQTT (battery voltage, PV power etc) and is updating frequently.
What is NOT working is the forwarding of the information the RP2W gathers from the LIN bus towards the MQTT. Also, changes done via the CP-Plus are not forwarded to MQTT. When trying to switch back to OS mode via sending payload 1 to topic 'service/truma/set/os_run', this is also not applied and RP2W stays in RUN mode.
As all connections are obviously working, I don't know how to help myself. Is there anything I can do or check?
Thank you for any helping idea or comment!
Hi,
I finally got my RP2W to work with the LIN UART converter and was able to switch on hot water, switch off, see CP-Plus time in Status page etc. This works fine.
MQTT is also set up (server is a Cerbo GX), and test number messages from the RP2W ("Send MQTT test message") show up in my MQTT explorer connected to the Cerbo GX. Also, all information from the Victron ecosystem is published on MQTT (battery voltage, PV power etc) and is updating frequently.
What is NOT working is the forwarding of the information the RP2W gathers from the LIN bus towards the MQTT. Also, changes done via the CP-Plus are not forwarded to MQTT. When trying to switch back to OS mode via sending payload 1 to topic 'service/truma/set/os_run', this is also not applied and RP2W stays in RUN mode.
As all connections are obviously working, I don't know how to help myself. Is there anything I can do or check?
Thank you for any helping idea or comment!