Library ESP8266WiFi.h missing in WebSocketClient_Demo.ino

[silvestret]

I have an Arduino UNO R3 and a module ESP8266 connected(RX= pin 3 and TX= pin 2).
I attached an image of my sketch.
Does your library will work with this sketch? if so, where can i get library ESP8266WiFi.h ?

Thanks

[morrissinger]

Are you trying to load this sketch onto the Arduino then? It doesn't have the right architecture for this sketch. This needs to be loaded onto the esp directly.

[silvestret]

Oh ok, so the board in arduino would be esp8266. I got the esp8266 of this photo.

So, your library is for esp8266 board, and it will not work with my esp8266 arduino module.
I am right?

[morrissinger]

Exactly. You have to set the board in your IDE to ESP8266, which is going to draw on a different set of libraries. Then, the way I have done it is to hook up the ESP through an FTDI board/cable to the USB on my laptop. If I recall, there is a pin on the ESP you have to pull down in order to get the chip to accept a firmware flash.

[silvestret]

Thank you so much for your response!

Greetings

[karanmakharia]

@morrissinger What if I want to load the sketch into Arduino? Do you know any other library that will work with this. Because the GPIO pins on ESP are not enough, so I will have to use Arduino board probable UNO or MEGA