get_bgp_neighbors returns incorrect local-as for NXOS #1964
Description
Description of Issue/Question
get_bgp_neighbors for NXOS returns global local-as setting rather than the per-session local-as
Looking at the internals of napalm it uses 'show bgp all summary vrf all' in the NXOS driver for gt_bgp_neighbors.
This command only returns the global ASN for the BGP router. It does not return the actual local-as for each BGP peering session. You'd need to combine the data from 'show running-config bgp' output in order to return the correct local-as for each individual BGP session.
Did you follow the steps from https://github.com/napalm-automation/napalm#faq
(Place an x between the square brackets where applicable)
- Yes
- [] No
Setup
napalm version
(Paste verbatim output from pip freeze | grep napalm between quotes below)
$ pip freeze | grep napalm
napalm==3.4.1
napalm-ansible==1.1.0
napalm-base==1.0.1
Network operating system version
(Paste verbatim output from show version - or equivalent - between quotes below)
Software
BIOS: version 5.6.0
NXOS: version 9.3(10)
Steps to Reproduce the Issue
lab-nxos# show bgp all summary vrf all
BGP summary information for VRF default, address family IPv4 Unicast
BGP router identifier 172.26.156.34, local AS number 65115.7000
BGP table version is 499, IPv4 Unicast config peers 2, capable peers 1
3 network entries and 3 paths using 732 bytes of memory
BGP attribute entries [2/344], BGP AS path entries [1/10]
BGP community entries [1/36], BGP clusterlist entries [0/0]
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd
11.11.11.1 4 65001 2932 2889 499 0 0 00:48:42 2
lab-nxos# sh run bgp
!Command: show running-config bgp
!Running configuration last done at: Tue Jun 13 16:50:39 2023
!Time: Wed Jun 14 09:25:54 2023
version 9.3(10) Bios:version 5.6.0
feature bgp
router bgp 65115.7000
router-id <redacted>
address-family ipv4 unicast
neighbor 11.11.11.1
remote-as 65001
local-as 12345
description test_descr
address-family ipv4 unicast