I am trying to send packets to my Raspberry Pi 4B (which has Nexmon patched onto its b43455c0 chip) from my laptop using iperf3. However, the packets are being received by eth0, not wlan0. We can't figure out how to send packets to wlan0, as there is no IP address listed when ipconfig is run. Wlan0 is gathering CSI data, but not from any packets my laptop is sending. What is the problem here? I think I fundamentally misunderstand what is going on.
I am trying to send packets to my Raspberry Pi 4B (which has Nexmon patched onto its b43455c0 chip) from my laptop using iperf3. However, the packets are being received by eth0, not wlan0. We can't figure out how to send packets to wlan0, as there is no IP address listed when ipconfig is run. Wlan0 is gathering CSI data, but not from any packets my laptop is sending. What is the problem here? I think I fundamentally misunderstand what is going on.