Following the manual installation guide makes Omarchy/Arch not show up in boot

[LolerHero]

System details

i5-12400F, MSI Z690-A Motherboard

What's wrong?

So I've spent the better of about 3 Days trying to figure this out and going on Discord for Support. Unfortunately even after extensive back and forth I wasn't able to fix my issue.

Since I'm fairly new to Linux and all it's about I'll try to provide as much information as possible.

What I wanted to achieve
Dual Boot Windows and Omarchy on my current drive

The Problem that arose
After following the Manual Installation Guide I was for one not able to install omarchy and the arch-system was not showing up in my boot options.

I actually tried two ways of the arch installation both unfortunately not yielding positive results.
Setting it up with ext4 and systemd-bootload and btrfs and limine.

These are the messages I got after trying to install Omarchy from the arch command line since I could not boot into the system outside of a bootable drive.

I hope this is all the info needed if not please tell me what else I need to provide.

[solsticesurfer]

I experienced a similar issue.

Set up a VM (VMWare Workstation 16 Pro) to try out Omarchy. Used the ISO off of the home page. Installed with all defaults. Install completes, reboots, bootloader displays "[config file contains no valid entries].

[yusuf-bot]

did u fidn a solution