Getting Values in Arduino IDE but volume control is not working

[ZeeoTwo]

I have an arduino nano sending signal on COM4 to my pc, i get every value corectly in the Arduino IDE

but when i turn on the deej program the volume is not changed no matter which knob i turn
deej-debug.exe sometimes doesnt recognize any of the knobs

and sometimes it detect 2/3 (i have 5 in total)

does anyone have an idea what could cause this behaviour and how could i fix it
i tried rollbacking the drivers but it didnt work, i also reintalled deej as a whole.
below is my config.yaml and device manager

[ZeeoTwo]

this is the exact version of the driver that i have

[torrabsolute2]

great timing on this. finally after the holiday and can sit down to see what's going on. i'm running into the same issue. I think there was an update this week that might have broken something. if i recall, I ran a windows update on around 11/26/24. i can confirm that my five pots are all outputting values, but deej is not chaning volume accordingly.

edit: this is the solution. installed the rolled back driver and rebooted. back to working again. #127 (comment)

[CardinalFangIsHere]

Can confirm the same issue

[jakesampson]

https://github.com/SHWotever/FakeCH340DriverFixer

Just installed this patch for my Fake Arduino chip and its working again.

[CardinalFangIsHere]

https://github.com/SHWotever/FakeCH340DriverFixer

Just installed this patch for my Fake Arduino chip and its working again.

Zero results for me, the deej app still starts and auto closes. Arduino ide app still reciving signals normally as before.
EDIT: my issue was caused by a change in COM port. Finally found the log and saw that was the issue.

[craksys]

Fixed for me.

https://github.com/SHWotever/FakeCH340DriverFixer

Just installed this patch for my Fake Arduino chip and its working again.

[drewzilla37]

Fixed for me! Thank you!

FakeCH340DriverFixer

[KD9FNA]

I too had this issue after a Windows update. The CH340 driver fixer was able to fix my issues

https://github.com/SHWotever/FakeCH340DriverFixer

Just installed this patch for my Fake Arduino chip and its working again.

[nlondrovic]

https://github.com/SHWotever/FakeCH340DriverFixer

Just installed this patch for my Fake Arduino chip and its working again.

I'm just here to commend that it worked for me. I updated the USB driver and now I can control deej with my Arduino :)