Default Autoneg setting should be "ON" for copper ports

[waliulislam]

Default autoneg settings for the ports that has copper transceiver should be "ON" instead of "OFF" Same goes with fanout ports.

root@AG2:~# opx-ethtool e101-041-0
Settings for e101-041-0:
    Channel ID:   0
    Transceiver Status: Disable
    Channel ID:   1
    Transceiver Status: Disable
    Channel ID:   2
    Transceiver Status: Disable
    Channel ID:   3
    Transceiver Status: Disable
    Media Type: QSFP 40GBASE CR4
    Part Number: 616750000
    Serial Number: CN01M31V4862ANV
    Qualified: Yes
    Administrative State: UP
    Operational State: DOWN
    Supported Speed (in Mbps):  [1000, 10000, 40000]
    Auto Negotiation : off
    Configured Speed   : auto
    Operating Speed   : 0
    Duplex   : full
root@AG2:~#