| layout | title |
|---|---|
documentation |
ZDP200 - ZWave |
{% include base.html %}
This describes the Z-Wave device ZDP200, manufactured by ACT - Advanced Control Technologies with the thing type UID of act_zdp200_00_000.
The device is in the category of Power Outlet, defining Small devices to be plugged into a power socket in a wall which stick there.
The ZDP200 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
Provides wireless dimming of lights, and ON/OFF control of lights connected to the Plug-In Lamp Module.
Plugs directly into wall outlet and provides a switched 230 VAC source. The programming button on the module is also a manual on and off switch.
Each Plug-In Lamp Module functions as an automatic repeater to other HomePro Modules to ensure full home coverage.
Use the button on the device.
Use Habmin or another zwave tool to exclude the device from the zwave mesh.
Button functions
-
Adds module under the command of Wireless Controller.
-
Local ON and OFF (push and release).
-
Local dimming (hold down).
The following table summarises the channels available for the ZDP200 -:
| Channel Name | Channel ID | Channel Type | Category | Item Type |
|---|---|---|---|---|
| Dimmer Switch | switch_dimmer | switch_dimmer | DimmableLight | Dimmer |
The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.
The switch_dimmer channel is of type switch_dimmer and supports the Dimmer item and is in the DimmableLight category.
The device has no configuration parameters defined.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The ZDP200 supports 1 association group.
Association group 1 supports 16 nodes.
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_MULTILEVEL_V1 | Linked to BASIC |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_PROTECTION_V1 | |
| COMMAND_CLASS_ASSOCIATION_V1 |
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.