| layout | title |
|---|---|
documentation |
TSE03 - ZWave |
{% include base.html %}
This describes the Z-Wave device TSE03, manufactured by Everspring with the thing type UID of everspring_tse03_00_000.
The device is in the category of Siren, defining Siren used by Alarm systems.
The TSE03 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is unable to participate in the routing of data from other devices.
The Wireless Door Bell & Push Button are a pair of Z-WaveTM enabled devices displaying the Z-WaveTM logo, operating at 868.42 MHz. Taking the role of a transmitter and a small Z-Wave controller, the Push Button sends signals of bell triggering to Door Bell (receiver) wirelessly after Button is pressed. The Push Button is compatible with other Z-Wave enabled devices.
As Primary Controller:
Push Button:
Press "I R" Key 3 times (within 1.5 secs), LED flashes on & off alternately.
Door Bell:
Press "I E R" Key 3 times (within 1.5 secs)
As Secondary Controller:
Press and hold "I"R" Key of Push Button for 10 secs.
Push Button:
Press "A E" Key 3 times (within 1.5 secs), and within 1 sec, press "A E" Key again for 5 secs until LED is off; LED flashes on & off alternately for 30 secs.
Door Bell:
Press "I E R" 3 times (within 1.5 secs).
The following table summarises the channels available for the TSE03 -:
| Channel Name | Channel ID | Channel Type | Category | Item Type |
|---|---|---|---|---|
| Switch | switch_binary | switch_binary | Switch | Switch |
| Binary Sensor | sensor_binary | sensor_binary | Switch | |
| Battery Level | battery-level | system.battery_level | Battery | Number |
Switch the power on and off.
The switch_binary channel is of type switch_binary and supports the Switch item and is in the Switch category.
Indicates if a sensor has triggered.
The sensor_binary channel is of type sensor_binary and supports the Switch item. This is a read only channel so will only be updated following state changes from the device.
The following state translation is provided for this channel to the Switch item type -:
| Value | Label |
|---|---|
| ON | Triggered |
| OFF | Untriggered |
Represents the battery level as a percentage (0-100%). Bindings for things supporting battery level in a different format (e.g. 4 levels) should convert to a percentage to provide a consistent battery level reading.
The system.battery-level channel is of type system.battery-level and supports the Number item and is in the Battery category.
This channel provides the battery level as a percentage and also reflects the low battery warning state. If the battery state is in low battery warning state, this will read 0%.
The device has no configuration parameters defined.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The TSE03 supports 1 association group.
Association group 1 supports 5 nodes.
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_BINARY_V1 | |
| COMMAND_CLASS_SENSOR_BINARY_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_BATTERY_V1 | |
| COMMAND_CLASS_ASSOCIATION_V1 | |
| COMMAND_CLASS_VERSION_V1 |
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.