| layout | title |
|---|---|
documentation |
ZW4101 - ZWave |
{% include base.html %}
This describes the Z-Wave device ZW4101, manufactured by Jasco Products with the thing type UID of ge_zw4101_00_000.
The device is in the category of Power Outlet, defining Small devices to be plugged into a power socket in a wall which stick there.
The ZW4101 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
Jasco's Z-Wave Plug-In Lamp and Appliance Module allows you the option to adjust mood lighting for all occasions within your home. Z-Wave is a radio frequency, mesh network technology specifically designed for use in residential lighting control. Every Z-Wave enabled wall switch is capable of relaying commands and utilizes two-way communications to ensure reliable operation throughout the entire home. The open-air, line-of-sight transmission distance is up to 100-Feet between devices.
- One Z-wave controlled AC outlet
- Remote ON/OFF control via the Z-Wave controller
- Manual ON/OFF control with the front panel pushbutton • One Always-ON pass-through AC outlet
- Space efficient design
- Does not block the lower outlet when plugged in to the upper outlet of a duplex wall receptacle. (This assumes that the duplex receptacle is mounted with the ground pin down.)
- Plugs and cords for connected devices route to the side allowing close placement of furniture
- Z-Wave certified
- Plug ZW4101 into wall
- Put controller in inclusion mode
- Press button on front of ZW4101
- Plug ZW4101 into wall
- Put controller in exclusion mode
- Press button on front of ZW4101
The following table summarises the channels available for the ZW4101 -:
| Channel Name | Channel ID | Channel Type | Category | Item Type |
|---|---|---|---|---|
| Switch | switch_binary | switch_binary | Switch | Switch |
Switch the power on and off.
The switch_binary channel is of type switch_binary and supports the Switch item and is in the Switch category.
The device has no configuration parameters defined.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The device does not support associations.
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_BINARY_V1 | Linked to BASIC |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_POWERLEVEL_V1 | |
| COMMAND_CLASS_PROTECTION_V1 | |
| COMMAND_CLASS_NODE_NAMING_V1 | |
| COMMAND_CLASS_VERSION_V1 |
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.