XGS1930-52HP

[Gamerayers]

So far, this is a great tool. I have a couple questions and some struggles.

1. My SFP+ is showing as 2.5gb and not 10. My switch doesn't support 2.5g, so not sure how to fix this.
2. Power for the switch is available only as a total and not individual POE, so the total power reported, I'm not sure how to get since it can't measure individual ports.
3. POE control and visibility. I can't tell where the PoE status is shown. Is it the little dot? If so, it is showing 3 of my ports that are POE as POE, but not the onther 5, so I'm not sure it is showing correctly. Also, is there a method to allow for control. I would love to have the ability to turn on/off based on some requirement or schedule even.

Otherwise, I love this. It is a great setup.

[partach]

Hi, thanks, glad you like it :)
I think your answers are in the discussions/readme:

1. you need to use a different 64bit OID, which is explained in the table on the readme. 32bit is max 2.5...
2. I do not have a POE switch myself so cannot test. This is a bit hampering progress on this.
3. the little dot is VLAN. See config setting of the card how to show POE. Per row you can change information. I think POE is part of it
   Have fun